E-Z Step Stencils
Our revolutionary laser welded E-Z Step stencils are used to facilitate an increased or decreased amount of solder paste volume and to deposit a specific brick height on selected PCB areas where you have mixed component technology, large ground pads, intrusive reflow or areas with co-planarity issues.
Advancements to Step Technology
![ez_logo-1024x277 ez_logo-1024x277](https://fctamexico.mx/wp-content/uploads/2022/06/ez_logo-1024x277-1.jpg)
![muscle-150x150 muscle-150x150](https://fctamexico.mx/wp-content/uploads/2022/06/muscle-150x150-1.png)
Stronger Weld
![increase-3-150x150 increase-3-150x150](https://fctamexico.mx/wp-content/uploads/2022/06/increase-3-150x150-1.png)
Greater Range in Steps
![line-150x150 line-150x150](https://fctamexico.mx/wp-content/uploads/2022/06/line-150x150-1.png)
Flatter Weld
SPECIFICATIONS
Step areas
Step ramp
Positional accuracy
Material thickness
Board side distortion
Environmentally friendly
Process
Thickness
Lead-time
20 – 150 microns with support for complex shapes
Controlled step ramp in 50 micron increments
< 10 microns on the step areas
+/- 2% (primary steel and step steel)
Flat with no impact
No hazardous chemicals or pollutants used in process
Provides increased control over your print process
Vary to generate exact paste volume & height for every component
Same day quick turn service available
![20161007_191616b 20161007_191616b](https://fctamexico.mx/wp-content/uploads/2022/06/20161007_191616b-scaled.jpg)
![4-14-1 4-14-1](https://fctamexico.mx/wp-content/uploads/2022/06/4-14-1.jpg)
![WeldMicro2-1024x1024 WeldMicro2-1024x1024](https://fctamexico.mx/wp-content/uploads/2022/06/WeldMicro2-1024x1024-1.jpg)