Water Based Stencil Cleaner
Easily Remove Stubborn Solder Paste
UC100X Ultra Clean stencil cleaner is a water based, neutral pH, and non-corrosive cleaner designed to remove a wide array of solder pastes from SMT stencils and out of apertures. The stencil cleaner is also effective in removing solder flux, uncured adhesives and board misprints. UC100X is intended for use in ultrasonic immersion and spray in air stencil cleaning machines. *UC100X is not intended for use as an under-stencil or hand wipe cleaner.
- Very good filterability; so therefore long bath life and low bath maintenance cost
- Low odor and no foaming when used in spray-in-air systems
- UC100X is formulated to be safe with all metals, adhesives, mesh and plastics used in stencil fabrication
UC100X Ultra Clean stencil cleaner was specifically developed to be compatible with permanent stencils coatings such as NanoSlic. NanoSlic Gold is inherently chemically resistant and will not be affected by the large majority of commercial stencil cleaners. But there are some stencil cleaners on the market that have high pH which will attack the coating over time during ultra sonic cleaning.
NanoSlic Gold stencil coating has been extensively tested with UC100X chemistry and has withstood over extended periods of cleaning cycles.